Intercure 200 Primer - 20 Litres

Intercure 200 primer, Rapid Recoat Epoxy for structural steelwork

A two component epoxy zinc phosphate/micaceous iron oxide primer, formulated on proprietary polymer technology, which provides rapid cure and overcoating even under low temperature conditions.

As a primer for steelwork intended for use in a wide range of aggressive environments, including offshore, chemical and petrochemical plants, industrial buildings, pulp and paper mills, power plants and bridges.
Suitable for overcoating within 3 hours in most climatic conditions hence speeding up production and throughput in fabrication shops.
Can also be used on site as a rapid curing, maintenance coating.

Typical thickness:                 75-100 microns dry, 112-149 microns wet
Coverage:                                8.90m²/litre at 75 microns d.f.t and stated volume solids 358 sq.ft/ US gallon at 3 mils d.f.t                                                            and stated volume solids.
Volume Solids                        67%
Pack Size:                              20 Litre containers
Colours Available:                 Grey or Red Oxide
Gloss Level                             Matt
Method of Application          Airless Spray, Air Spray, Brush, Roller

Drying Times:

Temperature          Touch Dry               Hard Dry           Minimum           Maximum
5°C (41°F)               40 minutes             4.5 hours          3 hours               Extended¹
15°C (59°F)             30 minutes             3 hours             2 hours               Extended¹
25°C (77°F)             20 minutes             2 hours             1 hours               Extended¹
40°C (104°F)          15 minutes             30 minutes      30 minutes         Extended¹


All Drying Time Data has been quoted at the typical thickness of 750 microns d.f.t
                                                          

Product Data Sheet
Product Safey Data Sheet - Part A
Product Safety Data Sheet - Part B

Carriage for this product is calculated by weight and is shown in the checkout area.