Intended Use

• For the maintenance of above water areas.
• Approved for the carriage of grain when used as part of an approved scheme.
• For use at Maintenance & Repair or On Board Maintenance.

Product Information

Colour  
CPA097-White, CPA098-Grey, CPA099-Red

Finish/Sheen    
Matt

Part B (Curing Agent)    
Not applicable

Volume Solids   
41% ±2% (ISO 3233:1998)

Mix Ratio            
Not applicable

Typical Film Thickness   
75 microns dry (183 microns wet)

Theoretical Coverage    
5.47 m²/litre at 75 microns dft, allow appropriate loss factors

Method of Application  
Airless Spray, Brush, Roller

Flash Point (Typical)       
Single Pack 35°C

Data Sheets

Product Data Sheet

Safety Data Sheet - White

Safety Data Sheet - Grey

Safety Data Sheet – Red

Limitations

It is recommended that Interprime 198 is not overcoated with epoxy coatings.

In certain regions, for specific customer requests and where cosmetic properties are not of concern, Interprime 198 may be applied without a cosmetic finish. Consult your regional technical centre for guidelines and details of colours available.

Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions. Consult your local International Paint representative for specific recommendations. Apply in good weather. Temperature of the surface to be coated must be at least 3°C above the dew point. For optimum application properties bring the material to 21-27°C, unless specifically instructed otherwise, prior to mixing and application. Unmixed material (in closed containers) should be maintained in protected storage in accordance with information given in the STORAGE Section of this data sheet. Technical and application data herein is for the purpose of establishing a general guideline of the coating application procedures. Test performance results were obtained in a controlled laboratory environment and International Paint makes no claim that the exhibited published test results, or any other tests, accurately represent results found in all field environments. As application, environmental and design factors can vary significantly, due care should be exercised in the selection, verification of performance and use of the coating.

The above information is based on current test data, health and safety information and application instructions supplied by our suppliers and manufacturers of the products. It is supplied for guidance and to the best of our knowledge is true and accurate. Customers should satisfy themselves to the suitability of the products in its intended use and no guarantee is given or implied as the conditions of actual use are beyond our control. If in doubt the customer should consult the designer of the project or the local building control. 

Fire Stopping Shop, disclaim any liability for loss, damage or other expense which may arise from the use of this information, data or products refereed to and reserve the right to amend or change any details without notice. This statement does not affect your statuary rights.