Clean the substrate before fixing the sealing strip. The areas to be sealed must be sufficiently dry, level, load-bearing, frost-free, clean and free from oil, grease, tar, gravel pockets, cracks, dust, dirt, mortar residues and other impurities or substances that may impair adhesion.Sharp or pointed irregularities must be removed.

On mineral, weakly bound but load-bearing substrates it is necessary to apply a TEROSON primer. Particularly suitable and recommended at low temperatures and on damp substrates of any kind is TEROSON PR PRIMER M+S. On wet substrates (no standing water), use TEROSON AD Adhesive Spray. 

The foil is applied in the 1st step with a width of ≥ 30 mm cleanly and efficiently to the profile. In the 2nd step, pull the release paper evenly off the selfadhesive coating. Pull at a slight angle, moving from the edge of the strip in the direction of the middle towards the perforation. Press the sealing strip using the hard TEROSON rubber roller. 

Dimension : 15 m x 1000 mm